// Diagnostics
Misfire Only Under Load: Ignition Breakdown or Fuel Starvation?
Published by DiagEdge · 19 November 2026 · 6 min read
A misfire that only shows up under load — accelerating, towing, climbing a hill — and is smooth at idle is telling you something specific. Under load, the cylinder holds more air, cylinder pressure is higher and the engine needs more fuel. A weakness that copes at idle gets exposed.
There are two usual suspects: ignition (the spark can't jump the gap at high cylinder pressure) and fuel (the system can't keep up with demand). Road-test data tells them apart.
Get data, not opinions
Do a road test that reproduces the misfire, with the scan tool recording:
- Misfire counters per cylinder (live data or Mode 6),
- Fuel trims under load,
- Fuel pressure (rail pressure on direct injection),
- RPM, load and throttle.
The pattern points to the cause
- One or two specific cylinders misfire → think ignition (coil, plug, lead or boot) or that cylinder's injector.
- Misfires spread across all cylinders, with long-term fuel trims climbing strongly positive under load → think fuel delivery: the engine is running lean when demand rises. See reading fuel trims.
- Fuel pressure that holds at idle but sags under load confirms fuel delivery — a weak pump, a clogged filter, a failing regulator, or on direct injection a weak high-pressure pump.
Ignition faults that only show under load
The voltage needed to fire a plug rises with cylinder pressure. So:
- Worn plugs with an enlarged gap — fine at idle, fail under load.
- A coil with breaking-down insulation — it may fire at idle but track to ground at high demand.
- A cracked or carbon-tracked coil boot, or moisture in the plug well.
Test it: swap the suspect coil to another cylinder. If the misfire moves with the coil, it's the coil; if it stays, look at the plug, injector or compression on that cylinder. On a scope, a secondary ignition pattern with a very high firing line or a short, ragged burn line under load points to the plug gap or a lean cylinder.
Other load-only causes
- A clogged or weak injector that can't deliver enough fuel at high demand.
- EGR opening when it shouldn't and diluting the charge — see EGR faults.
- A restricted exhaust (blocked cat) limiting power and raising cylinder temperatures.
If the misfire is random across all cylinders at any load, start with the P0300 random misfire guide instead.
Stuck on a fault like this?
DiagEdge gives every technician AI-powered diagnostic guidance across six specialist modules. First month just A$1.
Start for A$1 today