// Diagnostics
EVAP Leak Codes (P0442, P0455, P0456): Finding the Leak
Published by DiagEdge · 19 November 2026 · 6 min read
The evaporative emissions (EVAP) system traps fuel vapour from the tank in a charcoal canister and later burns it in the engine. The ECU periodically seals the system and checks it holds pressure or vacuum. When it doesn't, it sets a leak code:
- P0455 — large leak (or no flow) detected.
- P0442 — small leak, typically equivalent to a hole around 1 mm (0.040").
- P0456 — very small leak, around 0.5 mm (0.020").
Leak codes don't affect how the car drives, but they're an emissions fault and a common inspection failure.
Common causes
- The fuel cap — loose, cross-threaded, a worn seal, or a cheap aftermarket cap. The most common cause of a large-leak code, and worth checking first.
- Purge valve stuck open — the system can't seal. This can also cause rough idle or a hard start straight after refuelling, because vapour is drawn into the intake.
- Vent valve (canister close valve) stuck open, or blocked so the system can't vent properly.
- Cracked hoses or loose connections, especially brittle plastic lines near the tank and canister.
- A cracked canister, or a rusted filler neck.
- A large-leak code can also mean no flow — a purge valve stuck closed or a blocked line stops the test from pulling vacuum at all.
How to find it
- Check and test the fuel cap. Inspect the seal and use a cap tester if you have one. If the cap was loose, tighten or replace it, clear the code and let the system re-test (this can take several drive cycles).
- Run the EVAP self-test with the scan tool if it's supported. Many scan tools can also command the purge and vent valves — confirm each one opens and closes.
- Smoke-test the system. Connect the smoke machine to the EVAP service port (or the purge line), command the vent valve closed so the system is sealed, and introduce smoke at low pressure. Watch for smoke at the cap, filler neck, hoses, canister and valves. A UV dye in the smoke helps with very small leaks.
- Test the purge valve directly. With the engine off, it should hold vacuum (stay closed) when not commanded.
Tips
- Very small leak codes often trace to a hairline crack or a perished O-ring. Take your time with the smoke and good light.
- After any repair, clear the code and confirm the readiness monitor completes. EVAP monitors often need specific conditions, such as a cold start and a fuel level between about a quarter and three-quarters full.
Stuck on a fault like this?
DiagEdge gives every technician AI-powered diagnostic guidance across six specialist modules. First month just A$1.
Start for A$1 today