// Diagnostics

Crank, No Start: A Diagnostic Order That Finds the Fault Fast (Including Immobiliser)

Published by DiagEdge · 19 November 2026 · 7 min read

"It cranks but won't start" can cost hours if you jump straight to a favourite suspect. A fixed order — cheapest and most telling tests first — usually finds it in minutes.

First: crank or no crank?

If the engine doesn't crank at all, that's a starting-system fault: battery, cables, starter, relay, or a start-inhibit (park/neutral switch, clutch switch, or some immobilisers). This guide covers the case where it cranks normally but doesn't fire.

1. Codes and the security light

Read codes from the engine ECU and the immobiliser or body module. Then watch the security/immobiliser light on the dash while you turn the key. A light that flashes or stays on when it should go out points strongly at the immobiliser before you test anything else.

2. Is there an RPM signal while cranking?

Watch engine RPM in live data while cranking. It should show a cranking speed (often roughly 150–300 rpm). Zero RPM while the engine is clearly turning means the ECU isn't seeing the crankshaft sensor — and without it, most ECUs won't fire spark or injectors. That's a crank sensor, wiring or reluctor fault.

3. Spark

Check for spark with a proper spark tester (not by grounding a plug). No spark on all cylinders with a good RPM signal points at the ignition supply, the ECU's trigger output or the immobiliser.

4. Fuel pressure

Fit a gauge, or read rail pressure in live data on direct-injection and diesel engines. Check the pump primes when the key goes on. Low or zero pressure → pump, relay, fuse, filter, or (on some cars) an inertia/crash cut-off switch.

5. Injector pulse

With fuel pressure present, check the injectors are being pulsed — a noid light, or a scope on the injector control wire. Good RPM signal, good fuel pressure, but no injector pulse is a classic immobiliser signature: the ECU sees the engine turning but has been told not to fuel it.

6. Compression

If you have spark, fuel and pulse but no start, check compression. A relative compression test with a current clamp on the battery lead is quick; a stretched or jumped timing belt or chain shows up as low, even compression on every cylinder.

Recognising an immobiliser fault

Behaviour varies by make, but common patterns are:

Try the spare key. If the car starts on the spare, the problem is the first key (transponder or battery), not the car. If neither works, check the antenna ring around the ignition barrel and the module communication — a network fault can stop the ECU and immobiliser from talking.

Stuck on a fault like this?

DiagEdge gives every technician AI-powered diagnostic guidance across six specialist modules. First month just A$1.

Start for A$1 today

Related guides

EVAP Leak Codes (P0442, P0455, P0456): Finding the LeakMisfire Only Under Load: Ignition Breakdown or Fuel Starvation?Turbo Underboost and Overboost (P0299 and P0234): How to Find the Cause
← All diagnostic guides