// Charging & Electrical
Battery and Charging System Testing: What the Numbers Should Be
Published by DiagEdge · 19 November 2026 · 7 min read
Plenty of "bad alternators" and "bad batteries" are actually a bad connection. A methodical battery-and-charging check takes ten minutes and stops parts being replaced on guesswork.
1. Battery state of charge
Measure resting voltage with everything off, after removing surface charge (switch the headlights on for a minute, then off, and wait a few minutes). As a rough guide for a standard lead-acid battery:
- ~12.6 V — fully charged
- ~12.4 V — about 75%
- ~12.2 V — about 50%
- Below ~12.0 V — discharged
Charge a flat battery before judging it. A discharged battery can test as faulty when it's just empty.
2. Battery health
Voltage tells you charge, not health. Use a conductance tester (or a load test) set to the battery's actual type and rating — flooded, EFB or AGM, and its CCA. During cranking, voltage shouldn't fall much below about 9.6 V on a healthy battery and starter.
3. Charging voltage
With the engine running, a conventional system typically holds around 13.8–14.7 V. But many modern cars use smart (ECU-controlled) charging: they deliberately let voltage fall to around 12.5–13 V when the battery is full, and raise it under deceleration or high load. A low reading on these cars isn't automatically a fault — check what the ECU is commanding in live data before condemning the alternator.
4. Voltage-drop testing — the test that finds the real fault
A resistance (ohms) test on a cable can read fine and still fail under load. Voltage-drop testing measures the loss while current is flowing:
- Positive side: one meter lead on the battery positive post (not the clamp), the other on the starter's main terminal. Crank the engine.
- Negative side: one lead on the battery negative post, the other on the engine block. Crank.
As a rule of thumb, each side should lose well under 0.5 V while cranking (and much less on the ground side). Do the same between the alternator output and the battery positive, with the engine running and loads on, to check the charging path.
A high reading means resistance in that path — a corroded clamp, a loose ground strap or a failing cable — and it will cause slow cranking or undercharging no matter how good the battery and alternator are.
5. Alternator output and quality
Check the alternator can supply current with heavy loads on, and scope for AC ripple — a failed diode can pass a voltage check and still cause strange electrical faults.
After replacing a battery
Many cars (BMW, VW group and others) need the new battery registered or coded to the car, including its type and capacity. Without it, the charging system keeps charging as if the old battery were fitted — which can shorten the new one's life. Fit the correct type too: an AGM car needs an AGM battery.
And if the battery keeps going flat with everything testing good, look for a parasitic drain.
Stuck on a fault like this?
DiagEdge gives every technician AI-powered diagnostic guidance across six specialist modules. First month just A$1.
Start for A$1 today