// Wiring & Networks
ABS Wheel Speed Sensor Faults: Passive vs Active Sensors and How to Test Them
Published by DiagEdge · 19 November 2026 · 6 min read
An ABS or traction-control light with a wheel speed sensor code is one of the most common faults on modern cars — and one of the most commonly misdiagnosed, because the two kinds of sensor in use need completely different tests.
Know which sensor you have
- Passive (inductive) sensors — a coil and magnet next to a toothed tone ring. They generate their own AC sine wave: amplitude and frequency rise with wheel speed. Usually two wires, and you can measure their resistance (often in the high hundreds to low thousands of ohms — check the spec).
- Active sensors (Hall effect or magnetoresistive) — powered by the ABS module and reading either a toothed ring or a magnetic encoder ring built into the wheel bearing seal. Most are two-wire and signal by switching their current between two levels (commonly around 7 and 14 mA). They don't produce a sine wave, and a resistance test tells you very little.
That's the trap: a technician puts a meter on an active sensor, sees no AC voltage when spinning the wheel, and condemns a good sensor.
Common causes
- Tone ring damage — cracked, rusted or packed with debris (common on rings pressed onto CV joints).
- Wheel bearing faults — excessive play changes the air gap; a damaged magnetic encoder in the bearing seal gives a corrupted signal.
- Bearing fitted backwards — the encoder side must face the sensor.
- Wiring chafed at the suspension or hub, where it flexes with steering and travel.
- Metal debris stuck to the sensor tip.
- The sensor itself — less often than the above.
How to diagnose it
- Read all four wheel speeds in live data on a test drive. They should track each other closely in a straight line. A wheel that drops out, reads erratically or reads zero tells you where to look.
- Inspect before testing. Look at the tone ring, sensor tip, air gap and wiring. Check bearing play.
- Scope it.
- Passive: across the two wires with the wheel spun — you want an even sine wave with consistent peaks. A low or uneven peak each revolution points to a damaged or rusty tooth.
- Active: measure the signal as current (a low-amp clamp or a shunt), or back-probe the signal wire with the module connected. You should see a clean square-wave switching between the two current levels, with frequency rising with wheel speed.
- Check supply and ground to active sensors at the connector with the module connected.
Tip
Don't put a magnetic tool or a magnet near a bearing with a built-in encoder — it can corrupt the encoder's magnetisation and create a fault that wasn't there.
Stuck on a fault like this?
DiagEdge gives every technician AI-powered diagnostic guidance across six specialist modules. First month just A$1.
Start for A$1 today